Ricoh Aficio Color 3006 Service Manual page 321

TRANSFER BELT UNIT
[B]
[A]
6. Remove the cleaning unit retainers [A] from the cleaning unit (2 snap rings) and
remove the cleaning unit [B].
7. Lift up the belt unit and detach the upper part of the transfer belt bracket (2
screws). Lower the bracket [C], as shown.
8. Turn the belt tension release lever in the direction shown, to set it to the
"Transfer Belt Replacement" position.
9. Pull and turn the transfer belt [D], to remove it.
NOTE: 1) Hold the transfer belt at its edge. Never touch the belt surface. Any dirt
on the belt might cause poor copy quality.
2) After removing the transfer belt, clean each roller with water or alcohol.
When using alcohol, set the rollers aside for about 10 minutes to dry. If
alcohol remains on the rollers when the belt is replaced, the rollers may
adhere to the belt.
[A]
A259R406.WMF
[C]
6-50
24 February, 1999
[D]
A259R407.WMF