Table of Contents
Advertisement
DEVELOPMENT UNIT
[B]
3. Replace the developer cover (2 screws) and put the development unit [A] in the
drawer unit (2 lock screws [B]).
ø
CAUTION
1. When replacing the developer cover and development unit, do not apply
excessive force to the center of the development unit. The doctor gap
will bend, altering the developer scooping efficiency.
2. When replacing the developer cover, first press both ends of the cover
to confirm that the cover is properly set, and then secure it with the
screws. If the ends of the cover are not properly set, developer may fall
from the gap.
3. When installing the development unit in the drawer unit, hold the front
and rear end of the development unit. Holding the center of the
development unit may cause the development unit casing to bend, and
developer may spill. If this occurs, remove then reinstall the developer.
4. Make sure that the developer locks (forward and rear) are secured with
screws before rotating the revolver. This protects the developer
assembly and locks from damage.
5. Tighten the developer lock screws firmly. Loose lock screws will cause
the PG (Photoconductor Gap) to fluctuate.
[A]
6-44
24 February, 1999
[B]
A259R302.WMF
Advertisement
Table of Contents
