Table of Contents
Advertisement
CONTROLLER INTERFACE TYPE E (A848)
[A]
[F]
8. Attach 2 clamps [A] to the rear bracket of the copier.
9. Connect the power supply cord [B].
10. Remove the main board [C] (A258: 11 connectors and 7 screws, A259/A260:14
connectors and 7 screws).
11. Remove the shorting cable [D].
NOTE: Store this cable somewhere inside the machine because it may be
needed again.
12. Connect the 100 pin shield cable [E] to the LD main board (1 grounding wire
[H], 1 clamp [I]).
13. Reinstall the main board [C] (13 connectors, 7 screws).
14. Connect the I/F cable [F] to CN305 on the main board and clamp it as shown (1
grounding wire [J] and 1 clamp).
15. Install the cable shield plate [G] (2 M4 x 6 screws [K] and 1 M3 x 6 screw [L]).
A848I504.WMF
[J]
[K]
[D]
[B]
[E]
[G]
3-56
24 February, 1999
[C]
[E]
A848I505.WMF
[H]
[L]
A848I506.WMF
[I]
Advertisement
Table of Contents
