Table of Contents
Advertisement
24 February, 1999
Item
SP No.
[Display]
01-106: Fusing temperature display
[Roller Tmp. Display]
01-106-01
Lower roller
[Pressure Roller Temp]
01-106-02
Upper roller
[Hot Roller Temp]
1-108: Fusing unit detection [Fusing Unit Set]
01-108-00
[Fusing Unit Set]
01-109: [Fusing nip width measurement]
[Fusing Nip Band Wdth]
01-109-00
01-801: Motor speed adjustments [Motor Speed Adjustment]
01-801-01
Fusing motor speed adjustment:
Standard speed
[Fusing Mt: Normal Spd]
01-801-02
Paper feed motor speed adjustment:
Standard speed
[P Feed Mt: Normal Spd]
01-801-03
Drum motor speed adjustment:
Standard speed
[Drum Mt: Normal Spdl]
Default
Value Range
Step
Value
°C
to °C
°C
to °C
0
0: Detection
1
1: No detection
0: OFF
-
1: ON
0.0%
-0.1 to 1.0%
0.1
0.1%
-0.1 to 1.0%
0.1
-0.8%
-0.1 to 1.0%
0.1
5
SP7-
Description
902/3
Displays the surface temperature at the center of the
pressure roller (lower roller) in °C.
Displays the surface temperature at the center of the
hot roller (upper roller) in °C.
Set to 1 during PM as described in the PM flow chart,
to save time during PM. After the main switch is
turned off/on, this setting goes back to the default, "0"
automatically.
Feeds an OHP sheet and stops 3 times for 2 seconds
in between the hot and pressure rollers. Measure the
width of the three roller traces that are developed on
the OHP sheet because of these pauses. Set this SP
to '1' and press the Enter key to start feeding.
See Replacement & Adjustment – Nip Band Width
Adjustment for how to use this SP mode.
Do not adjust the factory settings.
SP TABLE
Advertisement
Table of Contents
