Table of Contents
Advertisement
24 February, 1999
Menu
Copy Reset
Max. Copy Q'ty
Original Tone
Margin
Adjustment
Set User Ratio
Initial Mode Set
Key Operator Tools
Use these tools to manage use of the machine.
Note
Enter a previously registered key operator code with the [ Number] keys.
The machine returns to its initial condition automatically after your
job is
finished. The time can be set from 10 to 300 seconds, or off.
1. Select [On] or [Off] with the ü û keys.
2. When you select [On], enter the time with the [Number] keys.
Then press the [OK] key.
Note
Default: 60 seconds
The maximum copy quantity can be set from 1 to 99.
Note
Default: 99
The beeper (key tone) sounds when you forgot to remove originals
after copying.
Note
Default: On
When the "Panel Tone" is set to Off, the beeper does not sound
even if the "Original Tone" is set to On.
You can adjust the margin width that is selected as a default in
Margin Adjust mode. You can change this setting as follows:
Select the margin
1.
2. Enter the margin width with the [Number] keys. Then press
the [OK] key.
• Metric version: left/20mm - right/20mm in 1mm steps
• Inch version: left/0.8" - right/0.8" in 0.1" steps
Note
Default:
• Metric version: left/10mm
• Inch version: left/0.4"
Up to 2 reproduction ratios which you frequently use can be
registered.
1. Select [Ratio 1] or [Ratio 2] with the ü û keys.
2. Enter your desired ratio with the [ Number] keys. Then press
the [OK] key.
Note
Default: 100 %
You can set the machine to recall program setting when the
machine is turned on or when modes are cleared.
Note
Default: Normal
Your service representative can store the program setting.
Your service representative can select whether the program
setting is recalled when the machine is turned on or when modes
are cleared.
Description
direction with the üûkeys.
4-17
USER TOOL
Advertisement
Table of Contents
