Table of Contents
Advertisement
24 February, 1999
[A]
[C]
[A]
3. Remove the left revolver stopper [A] from its storage location on the drawer unit
(1 screw) and fit it into the slot [B] at the rear of the revolver side panel and in
the notch [C] on the drawer unit stay.
ø
CAUTION
If you do not install the revolver stopper before removing the development
unit, the revolver may rotate, causing permanent damage to the
development unit or its holder.
4. Open the locks [D] at both ends of the development unit [E] (1 screw each) and
remove the development unit [E].
NOTE: When attaching and detaching the development unit, be sure to turn it in
the direction shown in the diagram. Turning the development unit in the
wrong direction may cause developer to spill from the toner hopper.
ø
CAUTION
Remove the development units one color at a time (never remove two or
more development units from the revolver at the same time). Removing two
or more development units at the same time may upset the balance of the
revolver. This will cause the revolver to revolve by itself, catching, hitting
or trapping your fingers inside the unit.
[B]
A259R301.WMF
6-41
DEVELOPMENT UNIT
[E]
[D]
A259R302.WMF
[D]
Advertisement
Table of Contents
