Right Bulkhead Clip Installation - Polaris 850 MATRYX INDY XC 129 2021 Manual

10. Once the adhesive bond is broken, remove the right-
side bulkhead clip from the chassis.
NOTICE
If the component is to be re-used, the adhesive must be
completely removed. See Bonded Component Surface
Preparation section.

RIGHT BULKHEAD CLIP INSTALLATION

NOTICE
Read and understand the following steps to ensure the
adhesive is applied correctly.
1. Verify the bulkhead clip and engine side support
brace are thoroughly cleaned and all residual
adhesive is removed from both parts.
2. Gather the fasteners that secure the bulkhead clip to
the engine side support brace.
3. Apply the adhesive to the right bulkhead clip as
outlined in Adhesive Application Patterns page 9.31.
4. Install the bulkhead clip. Loosely install the fasteners
q y
- that attach the bulkhead clip.
q
Side Support
Fasteners
w
Crossover Tube
Fastener
e
Clip Mounting
Fasteners
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
r
Lower Steering
Mount Fasteners
t
Idler Bracket
Fastener
y
Front Lower Over
Structure Fasteners
5. Torque fasteners to specification.
TORQUE
Side Support Fasteners
26 ft-lbs (35 N·m)
Crossover Tube Fastener
22 ft-lbs (30 N·m)
Clip Mounting Fasteners
26 ft-lbs (35 N·m)
Lower Steering Mount Fasteners
22 ft-lbs (30 N·m)
Idler Bracket Fastener
9 ft-lbs (12 N·m)
Front Lower Over Structure Fasteners
22 ft-lbs (30 N·m)
NOTICE
The fasteners must be torqued within the adhesive
working time of 6 to 10 minutes.
6. Reinstall the following components:
• Bulkhead Floor Plate (See Bulkhead Floor Plate
Installation page 9.35)
• Engine assembly (See Engine Installation page
3.39)
• Right side front suspension components (See the
Steering and Suspension Chapter)
• Tie rod boot
NOTICE
Allow the adhesive to cure for 24 hours at 68 °F (20 °C)
before placing the snowmobile back into service.
CHASSIS
q
:
w
:
e
:
r
:
t
:
y
:
9
9.41