Left Hand Control Adjustment - Polaris 850 MATRYX INDY XC 129 2021 Manual

LEFT HAND CONTROL ADJUSTMENT

IMPORTANT
Moving the left hand control without loosening the four
mounting screws will cause the housing locating pins to
cut grooves into the handlebar. When this occurs, the
left hand control may not clamp tightly to the handlebar.
If the left hand control was inadvertently moved without
loosening the screws and is loose, move the control
block slightly to the left or right on the handlebar to re-
locate the pins.
1. Loosen the brake master cylinder mounting screws
q
and move it away from left hand control.
IMPORTANT
Use care when moving brake master cylinder. Do not
damage the brake light signal wire.
NOTICE
If applicable, hand guards may need to be loosened or
removed to access and move the brake master
cylinder.
2. Loosen the four left hand control mounting screws
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
3. Move the control block to the desired position.
4. Torque control block screws to specification in the
sequence shown in the image.
Left Hand Control Screws:
20 in-lbs (2.3 N·m)
Do not over-torque.
5. Return the brake master cylinder to its specified
position. Verify clamp will not pinch brake light signal
wire. Torque clamp screw to specification
Brake Master Cylinder Clamp:
60-80 in-lbs (6.8-9 N·m)
Do not over-torque.
w
.
MAINTENANCE
TORQUE
TORQUE
2.43
2