Drive Clutch Removal; Drive Clutch Disassembly - Polaris 850 MATRYX INDY XC 129 2021 Manual

PVT SYSTEM

DRIVE CLUTCH REMOVAL

1. Remove the drive belt.
2. Prevent the drive clutch from rotating using the Drive
Clutch Holding tool or similar device.
Drive Clutch Holding Tool:
9314177–A
3. Remove the clutch bolt
from the drive clutch.
4. Obtain the Drive Clutch Puller.
Drive Clutch Puller:
2872085
5. Apply a light film of Polaris Premium Grease to the
puller threads. Tighten the puller into the clutch. If the
clutch does not come off, strike the clutch puller head
with a hammer. If the clutch does not "pop" off,
continue to tighten the clutch puller, and repeat this
step.
IMPORTANT
Do not use an impact wrench to remove or install the
clutch bolt or clutch puller. Damage to the clutch and/or
crankshaft can occur.
7.14
q w
, washer , and bushing
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual

DRIVE CLUTCH DISASSEMBLY

Sheaves must be marked to provide a reference point
for clutch balance and spider indexing. If the sheaves
are not marked and the spider washers are changed or
misplaced, the clutch may be out of balance and
damage to the clutch may result.
e
The clutch spring is under extreme tension, use caution
and wear eye protection when disassembling the
1. In a straight line, mark / etch the sheaves and the
cover with a black marker or a scribe.
2. Place the drive clutch in the clutch compression tool.
Clutch Compression Tool:
3. Compress the clutch in the compression tool, then
secure the chain.
NOTICE
WARNING
clutch.
8700220
© Copyright Polaris Inc.