ENGINE / COOLING / EXHAUST
EXHAUST REMOVAL
1. Remove the side panels and hood.
2. Using a commercially available spring removal /
installation tool, remove the exhaust springs
connecting the resonator and the tuned pipe.
3. Remove the exhaust spring
the resonator to the chassis.
4. Remove the exhaust spring
the resonator to the chassis.
3.152
q
w
connecting the front of
e
connecting the rear of
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
r
5. Cut the cable tie
that secures the EGT sensor to
the main harness.
6. Disconnect the EGT sensor
7. Remove the exhaust spring
pipe to the chassis.
8. Carefully separate the resonator and tuned pipe and
lift upward to remove the resonator from the chassis.
t
.
y
connecting the tuned
© Copyright Polaris Inc.