Bulkhead Clip Installation, Right - Polaris 850 PRO-RMK 155 2020 Manual

CHASSIS

BULKHEAD CLIP INSTALLATION, RIGHT

NOTICE
Read and understand the following steps to ensure the
adhesive is applied correctly.
1. Verify the bulkhead clip and engine side support
brace are thoroughly cleaned and all residual
adhesive is removed from both parts.
2. Gather the fasteners that secure the bulkhead clip to
the engine side support brace.
3. Apply the adhesive to the front, right side brace as
outlined in Adhesive Application Patterns page 9.23.
4. Install the bulkhead clip and fasteners
9.36
5. Torque fasteners to specification.
Lower Over Structure and Cross-Tube Fasteners
The fasteners must be torqued within the adhesive
q r
- .
6. Reinstall the NEW bulkhead floor plate. (See
Bulkhead Floor Plate Installation page 9.31)
7. Reinstall the following components:
• Right side front suspension components (See the
• tie rod boot
• Engine assembly (See Engine Installation page
Allow the adhesive to cure for 24 hours at 68° F (20° C)
before placing the snowmobile back into service.
9850060 R02 - 2020-2021 850 AXYS™ Long Track Snowmobile Service Manual
TORQUE
Clip Mounting Fasteners
26 ft-lbs (35 Nm)
22 ft-lbs (30 Nm)
working time of 6 to 10 minutes.
Clip Idler Bracket Fasteners
9 ft-lbs (12 Nm)
Bulkhead Clip Fasteners
26 ft-lbs (35 Nm)
steering / Suspension chapter)
NOTICE
q
:
w
:
e
:
r t
-
)
© Copyright Polaris Inc.