Drive Clutch; Identification; Drive Clutch Removal - Polaris 600 RUSH 2010 Manual

DRIVE CLUTCH

Identification

A
C
Every clutch will have the clutch part numbers etched on
to the cover (A). The "X" (B) marking is an index mark
where the clutch cover (C), clutch spider (D) and the
stationary sheave (E) should line up when the clutch is
assembled.

Drive Clutch Removal

NOTE: All clutch tools can be found at the beginning
of this chapter.
1. Remove the belt.
2. Place the clutch holding tool (PN 9314177-A) on the
drive clutch.
3. Remove the drive clutch retaining bolt. Note the
placement and number of washers on retaining bolt.
4. Insert the correct clutch puller into the retaining bolt
hole.
5. Tighten the puller into the clutch. If the clutch does not
come off, strike the clutch puller head with a hammer.
If the clutch does not "pop" off, continue to tighten the
B
D
clutch puller, and repeat this step.
Do not use an impact wrench to remove or install the
clutch bolt or clutch puller. Damage to the clutch and/or
PVT System
B
E
CAUTION
crankshaft can occur.
6
6.17