Chaincase Oil; Adjustments; Choke Adjustment - Polaris 2007 Two Stroke Service Manual

Chaincase Oil

Check the chaincase oil level at the interval outlined in this
maintenance section. Change the chaincase oil after the first 500
miles (800 km), then every 1000 miles (1600 km) or seasonally.
Maintain the oil level between the "safe" marks on the dipstick
whenever checking or changing oil.
1. Position the vehicle on a level surface
2. Remove the dipstick or fill plug and view the oil level on
the dipstick.
3. Add the recommended oil as needed. Do not overfill.
4. Level indication:
• Units equipped with a sight glass need should be filled
to the 1/2 way mark (A)
• Units equipped with a dip stick only need to be filled to
the safe marks located on the dip stick.
5. Clean the magnetic plug on the dipstick or fill plug.
6. Reinstall the dipstick or fill plug.
7. Remove the dip stick and check the fluid level on the
dipstick. Make sure it is within the "safe" level.
A

ADJUSTMENTS

Choke Adjustment

1. Flip the choke toggle to the "OFF" position.
2. Loosen locknuts (1) on the carburetor.
3. Turn sleeve adjusting nut (2) counter-clockwise until the
choke toggle shows no free play when pulled, then rotate
it clockwise until there is between 1/8 - 1/4in (3.2-.6.4mm)
free play (3).
NOTE: Verify the cable does not lift the plungers
when checking the free play.
1/8 - 1/4in. (3.2-6.4mm)
4. Tighten adjustment locknut (2).
5. On VM carburetors, repeat steps 2 and 3 for on the other
carburetor.
MAINTENANCE
2
1
3
3.17
3