Table of Contents
Advertisement
Configuration Switch
The configuration switch can be accessed at the rear of the module.
Figure 36
The module is shipped with all switches set to OFF, as shown above.
To perform any LAN configuration, SW1 and SW2 must be set to OFF.
N O T E
Table 15
Initialization ('Init') Mode
Link Configuration
Agilent 1290 Infinity Binary Pump User Manual
Location of Configuration Switch
Factory Default Settings
Bootp, all switches down. For details see
selection"
speed and duplex mode determined by auto-negotiation, for
details see
LAN Configuration
Configuration Switch
on page 228
"Link configuration selection"
13
"Initialization mode
on page 236
227
Advertisement
Table of Contents
