Table of Contents
Advertisement
3 Connect the power cable to the power connector at the back of the 1290
4 Connect the required interface cables to the rear of the 1290 Infinity Binary
In an Agilent 1290 Infinity System, the individual modules are connected by CAN cables. An
N O T E
Agilent 1200 Series Instant Pilot can be connected to the CAN bus of any module.
Connection to an Agilent data system is established through the built-in LAN port of the
detector. The LAN port of the detector must be used as the detector generates the highest
data rate of all modules. For more information about connecting the Instant Pilot or Agilent
Data System, please refer to the respective user manual. For setting up the LAN access,
see
Agilent 1290 Infinity Binary Pump User Manual
Infinity Binary Pump.
Pump.
Figure 7
Rear of Binary Pump
"LAN Configuration"
on page 223.
Installing the Module
Installing the Pump
3
33
Advertisement
Table of Contents
