Instrument Configuration - Agilent Technologies Infinity Binary Pump VL 1290 User Manual

Instrument Configuration

Use the Instrument Configuration dialog box to examine and, if necessary, modify
your instrument configuration. The Configurable Modules panel contains a list
of all modules available for configuration. The Selected Modules panel contains
the list of configured modules.
Auto Configuration: Under Communication settings, select either the Host Name
option or the IP address option and enter the appropriate value for the host
computer to enable automatic detection of the hardware configuration. The
system configures the instrument automatically with no further manual
configuration necessary.
The Binary Pump configuration parameters are in two sections:
• Communication
• Options
Communication: The parameters in this dialog box are detected automatically
during autoconfiguration.
• Device name,
• Type ID,
• Serial number,
• Firmware revision,
• Button Connection settings
Options:
• Pressure Unit:
• Seal wash installed:
• ISET installed:
Configure Solvent Type Catalogs: Displays the Solvent Type Catalogs dialog box,
which allows you to import and export solvent calibration data. See
"Importing Solvent Calibration Tables"
Please refer to the online help of your user interface for more detailed
information.
Agilent 1290 Infinity Binary Pump User Manual
Setting up the Pump with the Instrument Control Interface
select the pressure units from the drop-down list (bar, psi or MPa).
This check box is marked to indicate that an optional seal wash has been
detected during autoconfiguration.
This check box is marked to indicate that ISET is installed. Click ISET
Configurations to open the ISET Configuration dialog box, which allows you to
configure a sampler for the ISET emulation.
on page 68.
4
Using the Pump
45