Table of Contents
Advertisement
Two Methods to Determine the MAC Address
Enabling logging to discover the MAC address using BootP
If you want to see the MAC address, select the Do you want to log BootP requests?
check box.
1 Open BootP Settings from Start > All Programs > Agilent BootP Service >
2 In BootP Settings... check Do you want to log BootP requests? to enable logging.
3 Click OK to save the values or Cancel to discard them. The editing ends.
4 After each modification of the BootP settings (i.e. EditBootPSettings) a stop
5 Uncheck the Do you want to log BootP requests? box after configuring
Determining the MAC address directly from the LAN Interface card label
1 Turn off the instrument.
2 Read the MAC address from the label and record it.
3 Turn on the instrument.
Agilent 1290 Infinity Binary Pump User Manual
EditBootPSettings.
Figure 44
Enable BootP logging
The log file is located in
C:\Documents and Settings\All Users\Application Data\Agilent\BootP\LogFile
It contains a MAC address entry for each device that requests configuration
information from BootP.
or start of the BootP service is required for the BootP service to accept
changes. See
"Stopping the Agilent BootP Service"
"Restarting the Agilent BootP Service"
instruments; otherwise, the log file will quickly fill up disk space.
The MAC address is printed on a label on the rear of the module.
See
Figure 34
on page 224 and
Automatic configuration with Bootp
on page 245 or
on page 246.
Figure 35
on page 225.
13
LAN Configuration
241
Advertisement
Table of Contents
