Supported Firmware - Agilent Technologies 1290 Infinity II 2D-LC User Manual

3 Compatibility Matrix

Supported Firmware

Supported Firmware

Use the firmware, that is available in the Agilent 2D-LC Software USB flash drive
in folder Firmware.
Agilent 2D-LC Software has been tested with following firmware revisions:
Table 3
Device
Agilent 1100 Series, 1200 Series, and 1200 Infinity
Agilent 1200 Series, 1200 Infinity, and 1120 Compact LC
Agilent 1200 Infinity Hosted Modules
Agilent 1290 Infinity II Modules
Agilent Q-TOF, e.g., G6546A
1
Check the firmware instrument revision codes and firmware versions required for MH Acquisition for TOF
/ Q-TOF version. TOF and Q-TOF firmware revisions are M.XXX with M = Model identifier and XXX = FW re-
vision.
•
NOTE
•
•
•
•
•
Firmware can be found and is available under the following link:
NOTE
https://www.agilent.com/en-us/firmwareDownload?whid=69761.
Alternatively, see
2D-LC User Guide
Supported Firmware
Agilent releases LC firmware updates for so-called "firmware sets."
All Agilent LC instrument firmware sets have been designed and tested to be
truly and strictly backwards compatible for the installed software base (CDS).
The latest module firmware contained in each set is fully compatible and
interoperable with all other module firmware of the same set.
Agilent always recommends using the latest module firmware revision of a
firmware set to avoid interoperatibility issues.
Generally Agilent always recommends keeping the LC instrument firmware
current.
Do not mix firmware revisions between different sets. Agilent does not
guarantee operation of mixed firmware revisions from older or newer sets.
"Replace the Module Firmware"
Firmware
A.07.34
B.07.34
C.07.34
D.07.34
1
27.809
on page 292.
49