Define The 1D Pump Flow; Define The 2D Pump Flow - Agilent Technologies 1290 Infinity II 2D-LC User Manual

6 Method Parameters
Set the 2D-LC Method parameters
Define the
1 Set the
The selection of the solvents must be done in the standard pump method user
NOTE
interface.
Define the
1 Set the
2 To set and use idle flow, select check box Idle flow.
If Idle flow is not selected, the
NOTE
place.
Figure 68
2D-LC User Guide
1
D Pump FLow
1
D Pump Flow (range 0 – 5.0 mL/min).
This setting defines the flow in the first dimension being used while 2D-LC is
active.
Any changes of the Flow parameter in the 2D-LC UI are automatically
synchronized with the Method User Interface of the
Figure 67 Method User Interface of the
2
D Pump Flow
2
D Pump Flow (range 0 – 5.0 mL/min).
This setting defines the flow in the 2nd dimension being used while 2D-LC is
2
active (within D time segments where mode is not equal to Off).
The field to define the idle flow is active.
The setting in this field defines the flow in the 2nd dimension that is used
while the 2D-LC mode is Off (range 0 – 5.0 mL/min) and no cut is analyzed.
Interface for the flow settings of the
1
D pump
2
D Flow is also used when no
1 2
D pump and
1
D pump.
2
D analyses take
D pump
129