Coordinates - Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual

• System Contact
You can enter the name of a contact person responsible for managing the device. A
maximum of 255 characters are possible.
• System Location
You can enter the location where the device is installed. The entered installation
location is displayed in the selection area. A maximum of 255 characters are possible.
Note
Permitted characters
The following printable ASCII characters (0x20 to 0x7e) are permitted in the input
fields "System Name", "System Contact" and "System Location":
• 0123456789
• A...Z a...z
• !"#$%&'()*+,-./:;<=>?@ [\]_{|}~^`
Procedure
1. Enter the contact person responsible for the device in the "System Contact" input box.
2. Enter the identifier for the location at which the device is installed in the "System
Location" input box.
3. Enter the name of the device in the "System Name" input box.
4. Click the "Set Values" button.
Note: Steps 1 to 3 can also be performed with the SNMP Management Tool.
4.4.2.2

Coordinates

Information on geographic coordinates
In the "Geographic Coordinates" window, you can enter information on the geographic
coordinates. The parameters of the geographic coordinates (latitude, longitude and the
height above the ellipsoid according to WGS84) are entered directly in the input boxes of
the "Geographic Coordinates" window.
Getting the coordinates
Use suitable maps for obtaining the geographic coordinates of the device.
The geographic coordinates can also be obtained using a GPS receiver. The geographic
coordinates of these devices are normally displayed directly and only need to be entered
in the input boxes of this page.
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03
Configuring with Web Based Management
4.4 "System" menu
125