Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual page 154

Configuring with Web Based Management
4.4 "System" menu
• Security
Specify whether transfer of the e-mail from the device to the SMTP server is
encrypted. This is only possible when the SMTP server supports the selected setting.
Note
2-factor authentication (2FA)
2-factor authentication is not supported.
– SSL/TLS
– StartTLS
– None: The e-mail is transferred unencrypted.
• Test
Sends a test e-mail to the configured receivers.
• Test Result
Shows whether the e-mail was sent successfully or not. If sending was not
successful, the message contains possible causes.
Procedure
Configuring the SMTP server
1. Enable the "SMTP Client" function.
2. Enter the IP address or the FQDN of the SMTP server for "SMTP Server Address".
3. Click the "Create" button. A new entry is generated in the table.
4. Enter the name of the sender that will be included in the e-mail for "Sender Email
Address".
5. Enter the user name and password if the SMTP server prompts you to log in.
6. Under "Security", specify whether transfer to the SMTP server is encrypted.
7. Enable the SMTP server entry.
8. Click the "Set Values" button.
Note
Depending on the properties and configuration of the SMTP server, it may be
necessary to adapt the "Sender E-Mail Address" input for the e-mails. Check with the
administrator of the SMTP server.
154
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03