Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual page 235

• Port VID
Select the required VLAN ID. Only VLAN IDs defined in "VLAN > General" can be
selected.
If a received frame does not have a VLAN tag, it has a tag with the VLAN ID specified
here added to it and is sent according to the rules at the port.
• Acceptable Frames
Specify which types of frames will be accepted. The following alternatives are
possible:
– Tagged Frames Only
– All
– Untagged and Priority Tagged Only
• Ingress Filtering
Specify whether the VID of received frames is evaluated.
You have the following options:
– Enabled
– Disabled
Configuration procedure
1. In the row of the port to be configured, click on the relevant cell in the table to configure
it.
2. Enter the values to be set in the input boxes as follows.
3. Select the values to be set from the drop-down lists.
4. Click the "Set Values" button.
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03
The device discards all untagged frames. Otherwise, the forwarding rules apply
according to the configuration.
The device forwards all frames.
The device discards all tagged frames. The device forwards all untagged frames
and frames with a priority (Priority Tagged Frames). Otherwise, the forwarding
rules apply according to the configuration. If you have configured the Bridge mode
"Provider", this means that the device treats all incoming frames like untagged
frames.
The VLAN ID of received frames decides whether they are forwarded: To forward a
VLAN tagged frame, the receiving port must be a member in the same VLAN.
Frames from unknown VLANs are discarded at the receiving port.
All frames are forwarded.
Configuring with Web Based Management
4.5 "Layer 2" menu
235