Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual page 137

• Save
With this button, you can download files from the device. The button can only be
enabled if this function is supported by the file type and the file exists on the device.
• Delete
With this button, you can delete files from the device. The button can only be enabled
if this function is supported by the file type and the file exists on the device.
Note
Following a firmware update, delete the cache of your Internet browser.
Procedure
Uploading data using HTTP
1. Start the upload function by clicking one of the "Load" buttons.
Note
Files whose access is password protected
To be able to load these files on the device successfully, you need to enter the
password specified for the file in "System" > "Load&Save" > "Passwords".
A dialog for uploading a file opens.
2. Select the required file and confirm the upload.
The file is uploaded.
3. If a restart is necessary, a message to this effect will be output. Click the "OK" button
and run the restart. If you click the "Abort" button, there is no device restart. The
changes only take effect after a restart.
Downloading data using HTTP
1. Start the download by clicking the one of the "Save" buttons.
2. Select a storage location and a name for the file.
3. Save the file.
The file is downloaded and saved.
Deleting files using HTTP
1. Start the delete function by clicking the one of the "Delete" buttons.
The file is deleted.
Reusing configuration data
If several devices are to receive the same configuration and the IP addresses are
assigned using DHCP, the effort for configuration can be reduced by saving and reading
in the configuration data.
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03
Configuring with Web Based Management
4.4 "System" menu
137