Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual page 204

Configuring with Web Based Management
4.4 "System" menu
• Port Name
Here, enter a name for the port.
• MAC Address
Shows the MAC address of the port.
• Mode Type
From this drop-down list, select the transmission speed and the transfer mode of the
port. If you set the mode to "Autonegotiation", these parameters are automatically
negotiated with the connected device or network component. This must also be in the
"Autonegotiation" mode for this purpose.
Note
Before the port and partner port can communicate with each other, the settings must
match at both ends.
Note
"Mode Type" with combo ports
To be able to set the "Mode Type" of a combo port, change the "Combo Port Media
Type" to "rj45". If "auto" is set for the "Combo Port Media Type" and the RJ-45 port is
used, you cannot set the "Mode Type".
• Mode
Shows the transmission speed and the transmission mode of the port. The following
settings are possible:
– 10 Mbps full duplex (FD) or half duplex (HD)
– 100 Mbps full duplex (FD) or half duplex (HD)
– 1000 Mbps (full duplex)
• Negotiation
Shows whether the automatic configuration of the connection to the partner port is
enabled or disabled.
Note
Turning flow control on/off with autonegotiation
Flow control can only be enabled or disabled if the "Autonegotiation" function is
turned off. The function cannot be enabled again afterwards.
• Flow Ctrl. Type
Enable or disable flow control for the port.
• Flow Ctrl.
Shows whether flow control is working on this port.
204
The port is disabled and the connection to the partner device is terminated.
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03