Siemens SIMATIC NET SCALANCE SC-600 Configuration Manual page 122

Configuring with Web Based Management
4.4 "System" menu
• SNMP
Select the protocol from the drop-down list. The following settings are possible:
– "-" (SNMP disabled)
– SNMPv1/v2c/v3
– SNMPv3
• SNMPv1/v2 Read Only
Enable or disable write access to SNMP variables with SNMPv1/v2c.
• SNMPv1 Traps
Enable or disable the sending of SNMPv1 traps (alarm frames). You can configure
other settings in "System > SNMP > Traps".
• SINEMA Configuration Interface
If the SINEMA configuration interface is enabled, you can download configurations to
the device using STEP 7 Basic / Professional.
• DUID-Type
Specify which DUID type will be used. The DUID types are defined in RFC 3315.
– DUID-LLT
– DUID-EN
– DUID-LL
• Link-layer Address Plus Time (LLT)
The value is based on the link-layer address of the interface and a time stamp. The
value is regenerated each time the factory settings are restored.
• Vendor Enterprise Number (EN)
The value is based on the enterprise number specific to the vendor. The value is
regenerated each time the factory settings are restored.
122
Access to device parameters via SNMP is not possible.
Access to device parameters is possible with SNMP versions 1, 2c or 3. You can
configure other settings in "System > SNMP > General".
Access to device parameters is possible only with SNMP version 3. You can
configure other settings in "System > SNMP > General".
DUID is based on the link-layer address of the interface and a time stamp.
DUID is assigned by the vendor (EN = enterprise number).
DUID is based on the link-layer address of the interface.
SCALANCE SC-600 Web Based Management (WBM)
Configuration Manual, 10/2021, C79000-G8976-C475-03