3-4. Drum Entrance Side Block
3-4. Drum Entrance Side Block
3-4-1. S Tension Regulator Assembly Replacement
Outline
Replacement
1. Put the Unit into the Unthreading End Mode (Refer to step 2 in Section 3-1-3.)
2. Remove the S Tension Regulator Assembly
3. Install the S Tension Regulator Assembly
Adjustment after Replacement
4. Adjust the Tape Running (Refer to Section 5-3.)
Note
The component parts of the S tension regulator assembly are adjusted precisely in
the factory, then replace the whole assembly (A-8277-408-) in the field.
Tools
. Cleaning cloth:3-184-527-01
. Cleaning fluid: 9-919-573-01
Preparation
1. Turn the power off.
2. Remove the upper lid. (Refer to Section 1-1-1.)
3. Remove the plate MD. (Refer to Section 1-1-1.)
4. Remove the cassette compartment. (Refer to Section 1-1-2.)
5. Remove the MA-83 board and the DR-327 board. (Refer to Section 1-8.)
3-44
GY-2120WD/WS