Sony GY-2120WD Maintenance Manual page 92

3-2. Reel Block
Removal
1. Remove the Reel Table Assembly
Refer to step 1 in Section 3-2-1.
2. Remove the Brake Assembly
(1) Unhook the spring put on the reel shift plate
assembly.
(2) Remove the E ring, then remove the brake
assembly.
3. Remove the Brake Lining
Unhook the spring put on the brake arm block,
then remove the brake lining.
Installation
4. Install the Brake Lining
(1) Combine a new brake lining with the brake
arm block as shown in the figure.
(2) Hook the spring to the brake arm block.
5. Install the Brake Assembly
(1) Pass the brake assembly through the shaft of
the reel shift plate assembly.
(2) Hook the spring to the reel shift plate assem-
bly.
(3) Fix the brake assembly by the E ring.
6. Install the Reel Table Assembly
Refer to step 2 in Section 3-2-1.
Adjustment after Replacement
7. Confirm the Reel Table Height
Refer to Section 4-4.
8. Confirm the Reel Brake Clearance
Refer to Section 4-5.
9. Confirm the Reel Brake Release
Amount
Refer to Section 4-6.
3-12
E ring
Spring Brake assembly
Brake lining
Spring
Brake arm block
Remove/Install the Brake Lining
Reel shift plate
assembly
GY-2120WD/WS