Sony GY-2120WD Maintenance Manual page 146

3-6. Drum Exit Side Block
3. Remove the Capstan Motor
(1) Disconnect the connector on the capstan
motor board.
(2) Remove the two screws while holding the
capstan motor by hand.
c
Be careful not to drop the capstan motor.
Installation
4. Install the Capstan Motor
(1) Pass a new capstan motor through the hole of
the chassis in the direction shown in the
figure and tighten the two screws.
c
Be careful not to damage the capstan motor
shaft when passing the capstan motor through
the hole of the chassis.
(2) Connect the connector disconnected in (1) of
step 3 to the capstan motor board.
3-66
. . . . . Upper side
pp
Screw (PWH3 x 8)
Screw (PWH3 x 8)
Capstan motor
. . . . . Back side
Remove/Install the Capstan Motor
Capstan motor shaft
Capstan motor board
Connector
GY-2120WD/WS