Table of Contents
Advertisement
4-9. Slant Guide Slantness Adjustment
Adjustment
7. Loosen the screw
Loosen the fixing screw of the adjustment plate
by 1/4 to 1/2 turn.
8. Adjust the Slant Guide Slantness
(1) Insert a 3 mm flatbladed screwdriver into the
notch of the adjustment plate.
(2) Adjust the slantness of the slant guide so that
specification 3 is satisfied.
. If the tape runs in contact with the upper
flange of TG-10:
Move the adjustment plate in the direc-
tion indicated by the arrow A.
. If the tape runs in contact with the lower
flange of TG-10:
Move the adjustment plate in the direc-
tion indicated by the arrow B.
9. Tighten the Screw
Tighten the screw loosened in step 7.
10. Recheck the Tape Running at TG-10
Guide
(1) Put the unit into the unthreading end mode.
(2) Then put the unit into PLAY mode, and
check again that the tape running condition
satisfies specification 3 at TG-10 guide.
If the specification 3 is not satisfied, repeat steps
7 through 10 mentioned above.
11. Apply Locking Compound
Apply locking compound to the fixing screw of
the adjustment plate.
4-20
Adjustment plate
Fixing screw (PSW3 x 8)
(Apply locking compound.)
TG-10 guide
Slant Guide Slantness Adjustment
A
B
Notch
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
