Table of Contents
Advertisement
f) Display A-A Mode (Service setting command No. 72)
Enter "72" as a command and press the ENTER key.
The current A-A Mode setting will be displayed. (Default: OFF)
When this mode is ON, Early Warning (sense key/ASC/ASCQ=00/00/00, EOM bit=1) will not be
reported in the following cases for the Near EOP area.
Early Warning is also not reported when the approximately 3000 ID area in front of the LEOP
(Logical End of Partition) is defined as the NEOP (Near End of Partition), and the following are
performed for the NEOP area.
1) Data is written by the Write command
2) Filemark is written by the Write Filemarks command
3) The pointer is moved by the Space and Locate commands
SERV => 72
A-A Mode
: [0] OFF
SERV =>
g) Display COMP SW Mode (Service setting command No. 73)
Enter "73" as a command and press the ENTER key.
The current COMP SW Mode setting will be displayed. (Default: OFF)
When the mode is ON, priority will be given to the setting of the COMP switch on the front panel for
the setting of the compression/non-compression mode during recording.
(For details, refer to "2-5. Data Compression" of the protocol manual.)
SERV => 73
COMP SW Mode
: [0] OFF
SERV =>
GY-2120WD/WS
http://getMANUAL.com
6-2. Command Description
6-51
Advertisement
Table of Contents
Troubleshooting
