Table of Contents
Advertisement
6-3. Error Processing
2x 05
(ERROR 05) Reel FG test failed
Description:Abnormal supply reel or take-up reel operation was detected in a diagnosis during cassette insertion.
Detection conditions:
Subcode:
Possible cause:
Protection operation:
2x 06
(ERROR 06) Illegal tape tension in REC/PLAY mode
Description:Excessive tension was detected in the REC or PLAY mode.
Detection conditions:
Subcode:
Possible cause:
Protection operation:
6-164
1) When the supply reel FG or take-up reel FG count is less than the specified value with
the reel rotated
2) When the supply reel FG or take-up reel FG count is more than the specified value with
the reel stopped
None (Displays 00.)
. Supply or take-up reel FG sensor (SE-228 board) trouble or clearance adjustment defect
. Supply or take-up reel FG amplifier (DR-327 board or MS-54 board) trouble
. Supply or take-up reel drive circuit (DR-327 board or MS-54 board) trouble
. Servo adjustment defect on supply or take-up reel
. Supply or take-up reel brake trouble
. Supply or take-up reel brake solenoid drive circuit (MS-54 board) trouble
. Harness disconnection
Ejects the cassette.
When the tension value calculated from supply tension sensor output is more than 55 g
continuously for more than three seconds
None (Displays 00.)
. Cassette compartment trouble or installation defect
*
The reel did not rotate because the cassette was lifted-up from the specified position.
. Supply tension sensor or its related circuit (DR-327 board or MS-54 board) trouble
. Supply reel motor trouble
. Supply reel motor drive circuit (DR-327 board or MS-54 board) trouble
. Servo adjustment defect on supply reel and supply tension sensor
. Supply reel brake trouble
. Supply reel brake solenoid drive circuit (MS-54 board) trouble
. Harness disconnection
Stops the tape transport and enters the rest state.
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
