Sony GY-2120WD Maintenance Manual page 89

Removal
1. Remove the Reel Table Assembly
(1) Align one of the two notches at the bottom of
the reel table assembly with the groove
position of the reel shift plate assembly.
(2) Insert the L-shaped wrench into the notch at
the bottom of the reel table assembly along
the groove of the reel shift plate assembly.
(3) Loosen the screws fixing the reel table
assembly.
(4) Align another notch at the bottom of the reel
table assembly with the groove position of
the reel shift plate assembly.
(5) Loosen the screw in the same way as in step
(2).
(6) Remove the reel table assembly.
c
When the reel table assembly is removed, a
poly-slider washer for reel table height
adjustment may adhere to it. In this case,
remove the poly-slider washer from the reel
table assembly and return it to the reel motor
shaft position.
Installation
2. Install the Reel Table Assembly
(1) Clean the reel table assembly along the
circumference.
(2) Release the reel brake in the direction
indicated by the arrow and pass the reel table
assembly through the reel motor shaft.
c
Tighten the two screws fixing the reel table
assembly after the reel table height adjust-
ment is completed.
GY-2120WD/WS
S reel table assembly
Reel shift
plate assembly
Screw
Remove the Reel Table Assembly
S reel table assembly
S reel brake
S reel motor shaft
Install the Reel Table Assembly
T reel table assembly
Reel shift
plate assembly
Grooves
Notches
Screw
T reel table assembly
Cleaning
T reel brake
T reel motor shaft
3-2. Reel Block
3-9