Table of Contents
Advertisement
3-4. Drum Entrance Side Block
Installation
3. Install the S Tension Regulator
Assembly
(1) Clean the mounting surfaces of the S tension
regulator assembly and the chassis with a
cleaning cloth moistened with cleaning fluid.
(2) Set the S tension regulator assembly, and
tighten the screw (PWH3 x 8) and two L
cassette support spacer (S).
(3) Connect the connector into CN18 on the MS-
54 board.
(4) Fasten the harness with the harness clamper.
(5) Check that the harness is not on the cassette
compartment mounting surface (shaded
portion in the figure).
(6) Secure the L cassette support plate (S)
assembly to the L cassette support spacer (S)
with the two screws (P3 x 8).
Tightening torque : 78.5 x 10
(8 kgf.cm)
3-46
Connector
(CN1)
TR-78 board
_2
N.m
Harness clamper
Cassette compartment
mounting surface
Chassis
Screw (PS3 x 8)
Screw
(PS3 x 8)
Cleaning
Screw
(PWH3 x 8)
Cleaning
MS-54 board
Connector (CN18)
Install the S Tension Regulator Assembly
S tension regulator assembly
Cleaning
Cleaning
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
