3-6-6. T Drawer Arm Replacement
Outline
Replacement
1. Put the Unit into the Unthreading End Mode (Refer to step 2 in Section 3-1-3.)
2. Remove the T Drawer Assembly
3. Install the T Drawer Assembly
4. Confirm the T Drawer Assembly Operation
Adjustment after Replacement
5. Adjust the Slant Guide Slantness (Refer to Section 4-9.)
Note
It should not be used the stop washer once and again.
. Stop washer (d=2.3 mm): 3-669-596-00
Tools
. Cleaning cloth:
3-184-527-01
. Cleaning fluid:
9-919-573-01
. Slide calipers (or the equivalent)
Preparation
1. Turn the power off.
2. Remove the upper lid. (Refer to Section 1-1-1.)
3. Remove the plate MD. (Refer to Section 1-1-1.)
4. Remove the cassette compartment. (Refer to Section 1-1-2.)
GY-2120WD/WS
3-6. Drum Exit Side Block
3-77