Table of Contents
Advertisement
3-2. Reel Block
Note
The parts consisting reel motor is different between S side and T side. However,
how to replace the reel motor assembly is the same for both sides.
Tools
. L-shaped wrench (1.5 mm):
. Torque screwdriver (12 kg.cm)(JB-5252):
. Torque screwdriver's bit (+3 mm, l=90 mm): J-6323-430-A
. Grease (SGL-601):
. Oil:
. Cleaning cloth:
. Cleaning fluid:
Preparation
1. Turn the power off.
2. Remove the upper lid. (Refer to Section 1-1-1.)
3. Remove the plate MD. (Refer to Section 1-1-1.)
4. Remove the cassette compartment. (Refer to Section 1-1-2.)
5. Remove the bottom plate. (Refer to Section 1-1-1.)
6. Remove the MA-83 board and the DR-327 board. (Refer to Section 1-8.)
Removal
1. Disconnect the Flat Cable
(1) Disconnect the flat cable connected with MS-
54 board.
S side: CN10
T side: CN9
3-14
7-700-736-05
J-6252-520-A
7-651-000-10
7-661-018-18
3-184-527-01
9-919-573-01
Flat cable
MS-54 board
Disconnect the Flat Cable
CN9
CN10
GY-2120WD/WS
Advertisement
Table of Contents
Troubleshooting
