Sony GY-2120WD Maintenance Manual page 150

3-6. Drum Exit Side Block
3. Install the Pinch Press Assembly
Align the notch of the pinch press assembly with
the center of the pin and tighten the two screws.
4. Connect the Connector
Connect the connector into connector CN854 on
the PD-35 board.
Adjustment after Replacement
5. Confirm the Pinch Solenoid Operation
Refer to Section 6-2.
(SV18: Pinch Roller Solenoid Check)
6. Adjust the Pinch Press Clearance
Refer to Section 4-8.
3-70
Screw (PSW3 x 8)
Screw (PSW3 x 8)
PD-35 board
CN854
Pinch press
assembly
Notch
. Installing position of the pinch press assembly
Notch
Pin
Pinch press assembly
Install the Pinch Press Assembly
Pin
in the center
GY-2120WD/WS