@' : DRAM_CONT_CONT_DP
bit0 : read_write
0 : write
1 : read
bit1 : xfer_en
0 : off
1 : on
Normal value
@, : H_DPR_REG0_3 (EE/PB control)
Normal value
@. : H_DPR_REG0_2 (C1 error correction ability (e+n))
#/ : H_DPR_REG0_1 (C1 error correction ability (e))
#- : H_DPR_REG0_0 (C1 error correction ability (n))
C1 Error correction ability setting value
Normal value
Reduce the correction ability during writing than reading, so that no recording near the correc-
tion border remains on the tape.
#= : H_DPR_REG0_7 (IC test report (c1_enc))
#[ : H_DPR_REG0_6 (IC test report (c1_dec))
#] : H_DPR_REG0_5 ((not used))
#\ : H_DPR_REG0_4 (test mode control)
#; : H_DPR_REG0_B (C1 random error (Cch)) (Hex)
#' : H_DPR_REG0_A (C1 random error (Bch)) (Hex)
#, : H_DPR_REG0_9 (C1 random error (Ach)) (Hex)
Number of bytes which can be C1 error corrected when error was detected.
As the error byte number cannot be determined for blocks which could not be corrected, the
bytes are not added for random error.
The number of blocks which could be corrected are calculated from the C1 burst error.
00 (Hex) is 0 byte when it could be fully corrected or could not be fully corrected.
Normal value
GY-2120WD/WS
Write
Read
Out point Other
Inì point Other
00
02
01
01
Write
Read
A0
A1
00
03
6-2. Description of Commands
6-75