Table of Contents
Advertisement
2. Unthreading End Mode
Unthreading end mode means that the threading ring rotates in the clockwise
direction, then stops. (It is same state with EJECT completion mode.)
There are two ways of putting the unit into the unthreading end mode without
installing the cassette compartment.
Method 1: In the threading end atate, execute maintenance mode SV13: Thread-
ing Motor Check using a PC, and put the unit into the threading end
state. (Refer to Section 6-2.)
Method 2: Turn the M gear of the gear box assembly in the direction of the arrow
B with the power turned off state.
TG-4
TG-7
Capstan
Full erase head
TG-0
Tape clerner
GY-2120WD/WS
http://getMANUAL.com
CTL/TC RP head
TG-9
M gear
B
TG-1 (S tension regulator)
TG-2 (Entrance guide)
Unthreading End Mode
3-1. General Information for Parts Replacement
CTL/TC erase head
TG-3 (Exit guide)
TG-8 (T tension regulator)
TG-6
TG-5
(Threading roller)
Pinch roller
TG-10
Slant guide
3-5
Advertisement
Table of Contents
Troubleshooting
