Table of Contents
Advertisement
2x 02
(ERROR 02) Tape slacked in SEARCH/FF/REW mode
Description:Tape slacking was detected in SEARCH, FF, or REW mode.
Detection conditions:
Subcode:
Possible cause:
Protection operation:
c
Be sure to take out the cassette manually (refer to Section 1-5). Do not turn on the power again without
taking out the cassette. This may damage the tape.
GY-2120WD/WS
http://getMANUAL.com
1) When the take-up value is lower than the specified value with respect to the tape supply
value
2) When the relation between the capstan FG, supply reel FG, and take-up reel FG are out
of the specification
3) When the supply reel and take-up reel do not coincide in rotation direction continuously
for more than five seconds
None (Displays 00.)
. Cassette compartment trouble or installation defect
*
The reel did not rotate because the cassette was lifted-up from the specified position.
. Clearance adjustment defect of supply or take-up reel FG detection block
. Supply or take-up reel FG amplifier (DR-327 board or MS-54 board) trouble
. Supply or take-up reel motor trouble
. Supply or take-up reel motor drive circuit (DR-327 board or MS-54 board) trouble
. Capstan motor trouble
. Capstan motor drive circuit (DR-327 board or MS-54 board) trouble
. Capstan FG amplifier (DR-327 board or MS-54 board) trouble
. Take-up torque insufficiency during REW due to supply tension sensor or its related
circuit (DR-327 board or MS-54 board) trouble
. Servo adjustment defect on capstan, reel, and supply tension sensor
. Supply or take-up reel brake trouble
. Supply or take-up reel brake solenoid drive circuit (MS-54 board) trouble
. Harness disconnection
. Reel table height adjustment defect
. Tape path and drum troubles
. Tape abnormality (The winding state has a problem.)
Enters the protection mode. The normal state may be returned after the protection mode is
entered at the end of the tape.
6-3. Error Processing
6-161
Advertisement
Table of Contents
Troubleshooting
