Table of Contents
Advertisement
(7) Refer to section 4-2, and set the cassette
reference plate (L) (MW-088). As shown in
the right diagram, with the tip of the L
cassette holder (S) touching the back of the
reference plate lightly, tighten the fixing
screw. At this time, make sure that the part
indicated by the arrow in the diagram is not
floating and there is no clearance.
Adjustment after Replacement
4. Adjust the Tape Running
Refer to Section 5-3.
GY-2120WD/WS
Fixing screw
(WP3 x 5)
Install the S Tension Regulator Assembly
3-4. Drum Entrance Side Block
Cassette reference plate (L)
L cassette holder (S)
3-47
Advertisement
Table of Contents
Troubleshooting
