Other Adjustments; Adjustment Of The Position Of The Scanner And 2Nd/3Rd Mirrors Carriage - Minolta CF1501 Service Manual

4.

OTHER ADJUSTMENTS

4-1. Adjustment of the Position of the Scanner and 2nd/3rd
Mirrors Carriage
Requirement
• With the Scanner Assy fixed to the Scanner Drive Cables, there should be no gap
between the Scanner/Mirrors Carriage Positioning Jig and the Scanner and also
between the Scanner/Mirrors Carriage Positioning Jig and the 2nd/3rd Mirror Carriage.
This adjustment must be made in any of the following cases:
• The Scanner Drive Cable has been replaced.
• The Scanner Fixing Bracket has been removed from the Scanner Drive Cable.
• The Scanner Drive Cable comes unwound.
Adjustment Procedure
Scanner
positioning Screws
1. Remove the IR Rear Upper Cover, IR Front
Cover, IR Right Cover, and Original Glass.
2. Move the Scanner Assy so that the Scanner
Positioning Screw is aligned with the hole in the
upper frame.
3. Insert a screwdriver into the hole in the upper
frame and loosen the Scanner Positioning Screw.
4004D218AA
NOTE
• Do not remove the Scanner Positioning Screw.
4004D203AA
4. Install the Scanner Positioning Jigs between the
Scanner Assy and the 2nd/3rd Mirrors Carriage
Assy.
4004D219AA
D-90