(2)
Removal of the LED Unit
NOTE
• Whenever the Imaging Unit has been slid out of the copier, be sure to cover it with the
light blocking bag (black) or light blocking cloth for packing purposes and place it in a
dark place. Avoid leaving it to stand for a long time.
1. Open the Front Door.
2. Slide out the Imaging Unit (C/M/Y/Bk).
Unit Replacement Manual
NOTES
• After the Imaging Unit has been pulled out, place the Imaging Unit lock lever back into
the locked position.
• When sliding the Imaging Unit back in, make sure that the shutter is opened if the Imag-
ing Unit Lower Cover is not to be used.
3. Open the Right Door and Rear Left Cover.
4. Remove the Ozone Filter, Waste Toner Bottle, and Transfer Belt Unit.
5. Remove the Rear Cover and Rear Left Cover.
9. Unplug three connectors.
10. Remove five screws and the Toner Hopper Unit.
4004D046AB
6. Remove five screws and the cover.
4004D229AA
7. Remove one screw and unplug one connector on
the PIC Board.
4004D047AA
D-22