Table of Contents
Advertisement
10/REAR WHEEL
Removing the rear wheel
14.1
Installing the rear wheel
14.2
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Preliminary work
–
Raise the motorcycle with the lift stand. (
Main work
–
Press the brake caliper by hand on to the brake disc in order to press back the
brake piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove nut
–
Remove chain adjuster
wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swingarm.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
101389-10
–
Remove spacers
101390-10
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacers.
101390-11
–
Lift the rear wheel into the swingarm, position it, and insert wheel spindle
–
Attach the chain.
101391-10
.
1
. Withdraw wheel spindle
2
.
4
and bearing surface
1
p. 270)
p. 10)
only enough to allow the rear
3
of the spacers.
A
84
.
2
Advertisement
Table of Contents
