Table of Contents
Advertisement
13/BRAKE SYSTEM
7
7
0 0
0 0 6
6
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
pistons. Ensure that brake fluid does not overflow from the brake fluid reservoir,
using suction to remove it if it does.
Info
Make sure when pushing back the brake pistons that you do not press the
101374-11
brake caliper against the spokes.
–
Remove locking split pins
–
Clean the brake caliper and brake caliper support.
101376-10
–
Check that leaf spring
caliper support are seated correctly.
100397-01
–
Fit the brake linings, insert the bolt, and mount the locking split pins.
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
100398-10
–
Correct the brake fluid quantity to level
Guideline
Measurement of
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
101374-12
.
1
with membrane
.
2
3
, withdraw bolt
4
in the brake caliper and sliding plate
6
.
A
5 mm (0.2 in)
A
p. 268)
, and take out the brake linings.
5
in the brake
7
95
Advertisement
Table of Contents
