KTM 350 EXC-F EU 2012 Repair Manual page 29

01/FORK, TRIPLE CLAMP
–
Position the support ring.
–
Hold the seal ring with the shorter shoulder of the special tool.
Assembly tool (T1402S) (
–
Press the outer tube all the way in.
201355-10
–
Mount lock ring
Info
The lock ring must audibly lock into place.
200742-11
–
Install dust boot
–
Mount fork protector ring
200741-11
–
Mount adjustment tube
The adjustment tube extends 5 mm (0.197 in) out from the cartridge and can
be pressed inward against the spring force.
The adjustment tube extends more than 7 mm (0.276 in) out from the car-
tridge and cannot be pressed inward against the spring force.
–
Screw on water excluder
Info
The water excluder must be screwed on tightly against the stop. Do not use
200725-11
a tool.
–
Mount the special tool on the cartridge.
Gripping tool (T14026S1) (
Info
The special tool must be used in order that the adjustment tube is not
raised. Otherwise, oil will reach the piston rod.
–
Push the cartridge into the inner tube.
–
Mount and tighten compression damping fitting
Guideline
Compression damping fitting
Info
If the cartridge turns as well, press the piston rod slightly to the side.
200726-10
p. 283)
.
2
.
1
.
B
of the rebound damping in the cartridge.
7
to the stop.
C
p. 282)
M29x1
.
8
35 Nm
(25.8 lbf ft)
27