Assembling The Rebound Adjuster; Assembling The Seal Ring Retainer - KTM 350 EXC-F EU 2012 Repair Manual

04/SHOCK ABSORBER, SWINGARM

Assembling the rebound adjuster

8.21

Assembling the seal ring retainer

8.22
–
Grease O-ring
Lubricant (T158) (
–
Mount rebound needle
Info
Push in the rebound needle to the point where it is possible to mount the
rebound damping adjusting screw.
–
Mount rubber plug
200808-10
–
Lubricate spring, balls
Lubricant (T159) (
–
Screw in the rebound damping adjusting screw
–
Mount and tighten screw sleeve
Guideline
Screw sleeve
–
Screw out the rebound damping adjusting screw
200809-10
–
Grease the O-ring of the rebound damping seat.
Lubricant (T159) (
–
Mount and tighten rebound damping valve seat
Guideline
Rebound damping valve
seat
Info
200810-10
The rebound damping valve seat must be pressed inward before tightening.
–
Mount dust boot
Mounting sleeve (T1204) (
–
Grease the sealing lip of the dust boot.
Lubricant (T625) (
200792-10
–
Grease the O-ring groove.
Lubricant (T158) (
–
Mount O-ring
–
Mount washer
200793-10
of the rebound needle.
1
p. 270)
in the piston rod.
2
.
3
and O-ring .
4 5
p. 270)
.
7
p. 270)
M8x1
with the special tool.
1
p. 280)
p. 271)
p. 270)
.
2
.
3
all the way.
6
M14x1 18 Nm
(13.3 lbf ft)
to the stop.
6
.
8
6 Nm Loctite ®
(4.4 lbf ft)
53
2701