01/FORK, TRIPLE CLAMP
Installing the lower triple clamp (EXC‑F EU/AUS/USA, XCF‑W)
5.24
3
0 0 3
2
0 0 2
1
0 0 1
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
101329-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
101330-10
–
Position the upper triple clamp with the steering.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws
.
5
Guideline
Remaining screws, chassis
101427-10
–
Position the fork legs.
Info
The topmost milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
101332-10
(XCF‑W, EXC‑F EU/AUS)
–
Tighten screws
Guideline
Screw, bottom triple clamp
101333-10
. Remove protective ring
4
p. 270)
1
and O-ring
.
2
3
but do not tighten yet.
4
toward the front.
6
.
7
.
5
is correctly positioned.
M6
10 Nm (7.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
33