Removing The Battery; Installing The Battery; Charging The Battery - KTM 350 EXC-F EU 2012 Repair Manual

11/WIRING HARNESS, BATTERY

Removing the battery

15.5
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.

Installing the battery

15.6

Charging the battery

15.7
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Preliminary work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Disconnect negative cable
–
Pull back the positive terminal cover
the battery.
–
Detach rubber band
–
Lift the battery up and out.
101393-10
Main work
–
Insert battery into the battery compartment with the terminals facing to the front.
Battery (YTX4L-BS) (
–
Reconnect rubber band
–
Connect positive cable
Guideline
Screw, battery terminal
Info
Contact disks
sockets
–
Slide positive terminal cover
101394-10
Subsequent work
–
Mount the seat. (
p. 69)
of the battery.
1
and disconnect the positive (plus) cable of
2
at the bottom.
3
p. 196)
.
1
and negative cable
2
M5
must be mounted between battery terminals
A
with the claws facing up.
5
over the positive terminal.
6
p. 70)
.
3
2.5 Nm
(1.84 lbf ft)
and cable
4
92