13/BRAKE SYSTEM
–
Mount bleeder cover
Bleeder cover (00029013006) (
–
Connect the bleeding device.
Bleeding device (00029013100) (
201602-10
–
Open shut-off valve
Info
Follow the operating instructions of the bleeding device.
–
Ensure that the filling pressure is correctly set at pressure gauge
adjust the filling pressure at pressure regulator
Guideline
Filling pressure
201494-11
–
Pull off dust cap
Bleeding device (00029013100) (
–
Open bleeder screw
Info
Bleed until new brake fluid emerges from the bleeder bottle hose without
bubbles.
–
Tighten the bleeder screw.
201603-10
–
Close shut-off valve
–
Open the bleeder screw again until no more brake fluid emerges.
Info
This prevents overfilling of the brake fluid reservoir.
–
Tighten the bleeder screw. Remove the hose of the bleeder bottle. Attach the dust
cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
–
Stand the vehicle upright.
–
Top up the brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Fit and tighten plug with oil screen and O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.
–
Check the foot brake lever for a firm pressure point.
201600-10
.
2
p. 272)
p. 272)
.
3
2... 2.5 bar (29... 36 psi)
of the bleeder screw. Connect the hose of the bleeder bottle.
4
p. 272)
by approx. one-half turn.
5
.
3
.
A
p. 268)
. If necessary,
A
.
B
104