41/Throttle Valve Body; Throttle Position Sensor Circuit A - Checking The Basic Settings; Throttle Position Sensor - Adjusting The Basic Settings - KTM 350 EXC-F EU 2012 Repair Manual

41/THROTTLE VALVE BODY

Throttle position sensor circuit A - checking the basic settings

27.1
Condition
The diagnostics tool is connected and running.
–
Select the model.
–
Select "ECU Diagnostics".
–
Highlight the "Injection management EXC" control unit.
–
Press "Continue".
–
Select "Measured Values".
–
Highlight "Fuel management general".
–
Press "Continue".
–
Mark the "Throttle position sensor voltage circuit A (THAD)" and "Throttle position sensor signal circuit A (ATP)" measured values and
deselect the other parameters using "Select live data".
Throttle position sensor circuit A
Basic position - voltage "THAD"
Throttle position sensor circuit A
Signal "ATP"
» If the displayed value does not correspond to specifications:
–
Throttle position sensor - adjust the basic settings. (

Throttle position sensor - adjusting the basic settings

27.2
Condition
The diagnostics tool is connected and running.
–
Select the model.
–
Select "ECU Diagnostics".
–
Highlight the "Injection management EXC" control unit.
–
Press "Continue".
–
Select "Measured Values".
–
Highlight "Fuel management general".
–
Press "Continue".
–
Mark the "Throttle position sensor voltage circuit A (THAD)" and "Throttle position sen-
601760-10
sor signal circuit A (ATP)" measured values and deselect the other parameters using
"Select live data".
–
Loosen screw
–
Set "Throttle position sensor voltage circuit A (THAD)" to the setpoint value. Tighten
screw .
1
Info
The value of "Throttle position sensor signal circuit A (ATP)" must equal the
setpoint value.
Throttle position sensor circuit A
Basic position - voltage "THAD"
Throttle position sensor circuit A
Signal "ATP"
» If the displayed value is equal to the setpoint value:
–
Open and close the throttle grip fully ten times.
–
Check the measured values of "Throttle position sensor voltage circuit A
(THAD)" and "Throttle position sensor signal circuit A (ATP)" again.
–
Complete the procedure with 2x "Back".
–
"Read trouble code" selected.
–
Complete the procedure with "Back".
–
Select "Delete trouble codes".
–
Complete the procedure with "Back".
0.601 V
±0.004
0 %
p. 190)
.
1
0.601 V
±0.004
0 %
190